Surface Ceiling or Surface Wall Mount
1. Secure the adjustable crossbar to the J-box using the (2) 8-32 x 1”
screws (supplied). Use the slotted portion of the adjustable crossbar to
mount to the J-box and position such that the portion with the threaded
holes is facing out from the J-box. (Fig. 5)
2. Punch out the desired knockouts located in the top or side of the
enclosure for ceiling or wall mounting, respectively. Insert the plastic
grommet (supplied) into the center hole.
3. Attach the canopy to the enclosure using the (2) M4 x 8mm screws
(supplied).
4. Insert the (2) plastic rivets (supplied) into the (2) unused M4 holes in the
enclosure.
5. Remove one of the enclosure end caps by removing the (4) screws and
set all aside. Slide the trimplate assembly out of the housing.
6. Connect the battery/batteries to the PCB.
7. Slide the trimplate assembly partially into the enclosure so that the wires
can be routed through the canopy, then route the wires through the
canopy.
8. Slide the trimplate assembly fully into the enclosure and remove the
excess slack from the wires inside the enclosure by pulling them farther
out through the canopy. Replace the end cap and secure with the
(4) screws from Step 5.
9. Make electrical connections; see
Electrical Connections
section.
10. Secure the fixture to the adjustable crossbar using the (2) M4 x 40mm
screws (supplied). Ensure the canopy is securely fastened against the ceiling or wall and will not rotate.
11. Connect the EXIT panel assembly to the PCB with the EXIT panel connector, then secure by sliding into the EXIT panel
slot in the trimplate until it locks into place. Verify that the EXIT panel is properly secured by lightly pulling the EXIT
panel assembly away from the trimplate. (Fig. 6)
NOTE:
If using a single face EXIT sign, it may be necessary to change the direction the EXIT panel is facing. This is
determined when the EXIT panel assembly is secured within the trimplate. To change the direction of the EXIT panel,
pull one end of the EXIT panel out of the EXIT panel light bar, followed by the other end. Rotate the EXIT panel 180°
then reinstall the EXIT panel within the EXIT panel light bar.
12. Remove the protective film from the EXIT panel to complete the installation.
Remote Lamps
If the fixture is installed with the remote capable option, the fixture can support 3.6VDC 3W max. remote capabilities.
Compatible with two RL1 remote lamps (non-G2 models) or one RL1 remote lamp (G2 models).
To connect the remote head(s) to the fixture:
1. Remove the jumper, if present, and discard.
2. Connect the remote wires to the remote connector. Yellow is positive (+) and purple is negative (-).
3. Plug the remote connector into the female connector on the PCB labeled Lamp 3.
Fig. 6
Lamp Head
EXIT Panel
Connector
EXIT Panel
EXIT Panel
Light Bar
Protective
Film
Fig. 5
Above: Top Mount
Right: Wall Mount
J-box
Adjustable
Crossbar
Canopy
Enclosure
End Cap
J-box
J-box
NY900C Series
Installation Instructions
10070221
R
EV 3 - 01/21
800-533-3948 www.barronltg.com
3
