QuadAir Multiplayer Hockey Table
Instruction Manual
18
For assistance call:
1+(716) 866-0054
Error Lights
Check the Instruction Manual against the PC Board error codes to
begin. For the digital models, the LED screens above each goal will show an
errors code when the table is out of order. When there is an error, press the
Troubleshooting Button.
Light A: Goal Sensor Error Light Signal
This light will flash if a goal is scored. However, if this light is
steadily on and there are no pucks in the table, this part may
need to be replaced or there may be debris blocking the
sensor. The release solenoid might not be retracting which
could cause a puck to remain in the view of the sensor.
Light B: Start Button Light Signal
Light C: Coin Mechanism Error Light Signal
This light will flash when a coin is passed through the coin acceptor. However, if this light is
steadily on, check to make sure that the N.C./N.O. (“Normally Closed” or “Normally Open”)
setting is set to N.O. The Coin Mechanism may need to be replaced if the problem persists.
Light D: Ticket Error Light Signal
This light will flash as the tickets are being dispensed. However, if this light is steadily on,
check to make sure the N.C./N.O. and 0V/5V settings are set to 0 and N.O. The ticket
mechanism may need to be replaced if the problem persists.
Light E: Rail Noise Strike Error Light Signal
This light will flash when a puck hits a rail to signal the PC Board to make a strike noise. If
the light is steadily lit, adjust the VR (Variable Resistor) until it turns off.
