11
OPERATION
2
The 4050 Transporter can be powered by one of three means:
• Internal battery
•
External Battery
• Mains power
This chapter outlines the set-up and powering of the Barrett 4050 Transporter.
Internal Battery
It may be necessary to install or change the internal battery to be suitable for
specific circumstances. It is recommended to do this before any emergency
situations take place to provide quick and efficient mobilisation when they do
occur.
WARNING: DISCONNECT MAINS POWER BEFORE ATTEMPTING ANY INSTAL
-
LATION/MAINTENANCE ON THE 4050 TRANSPORTER.
THE TRANSCEIVER MUST BE REMOVED BEFORE THE BATTERY CAN BE
INSTALLED.
To remove the transceiver, disengage the circuit breaker and disconnect all rear
cables. Hold down the two black tabs on the right hand side of the transceiver
mounting plate while slightly lifting the transceiver. Pull the transceiver to the
right and then up to release it. Disconnect the remote head L-shaped connector
on the front of the transceiver.
Fitting the Battery
The battery hold-down system
has been designed to fit a variety
of battery sizes. Please follow the
steps below to fit a battery.
1.
Check circuit breaker is dis-
engaged i.e. the red button
pressed and the yellow lever
in a downward position.