1320/1620 Owner’s-Operator’s Manual
8/30/18
Page 4 of 19
BARRETO MANUFACTURING, INC. EQUIPMENT WARRANTY
Barreto Manufacturing, Inc. warrants all BARRETO equipment to be free of defects in material
and workmanship for a period of one (1) year, dating from delivery to the original user.
This Warranty is in lieu of all other warranties, whether written or implied, and is limited to:
1.
Replacement of parts returned to the dealer and/or factory and determined defective upon
inspection. (Replacement for parts to dealers shall be at dealer cost plus shipping charges.)
2.
Time for pick-up and/or delivery, transportation or service calls by dealers is excluded.
Manufacturer reserves the right to determine reasonable time required for repair.
Warranty does not apply to damage caused by abuse or neglect. Time and materials required for
normal maintenance and service are also excluded from warranty coverage.
Engines, engine accessories, batteries and tires are warranted by the original manufacturers
and are not covered by the Barreto Equipment Warranty.
Wear parts such as tiller tines,
sprockets, bearings, trencher chain parts including teeth, stump grinder cutting teeth & holders,
etc. are also excluded unless it can be determined that a defect has contributed to premature wear.
HOUR METER
The
DGI
®
TACH/HOUR
hour meter tracks the hours of machine operation in order for routine
maintenance to be performed on a timely basis.
Your
DGI
® hour meter is pre-set at the
DGI
® factory to go into
Flash Alert
mode at 25-hour
intervals. Although the engine manufacturer does not require changing engine oil this often,
due
to heavy-duty use and extreme conditions inherent to tiller use, Barreto Manufacturing
strongly recommends frequent oil changes.
Refer to this manual for equipment service requirements and to the
Engine Manual
for engine
service requirements.
While
Flash Alert
is active, hold the tip of the RESET TOOL (Key Kancel Wand) against the
meter as shown. Within several seconds, the display will stop flashing indicating the Service
Interval has been reset. If the wand gets lost, a small mechanic’s pick-up magnet will work.
RESET TOOL
