barox Kommunikation
13
Mounting Installation
DIN-Rail Mounting
The DIN-Rail is pre-installed on the industrial Ethernet switch from the factory. If the DIN-Rail is not on
the industrial Ethernet switch, please see Figure 3.1 to learn how to install the DIN-Rail on the switch.
Figure 3.1: The Rear Side of the Switch and DIN-Rail Bracket
Follow the steps below to learn how to hang the industrial Ethernet switch.
Step 1.
Use the screws to install the DIN-Rail bracket on the rear side of the industrial Ethernet
switch.
Step 2.
To remove the DIN-Rail bracket, do the opposite from Step 1.
Step 3.
After the DIN-Rail bracket is installed on the rear side of the switch, insert the top of the DIN-
Rail on to the track as shown below in Figure 3.2.
Figure 3.2: Insert the Switch on the DIN-Rail
Step 4.
Lightly pull down the bracket on to the rail as shown below in Figure 3.3.
