Baroness TDA1200, Service Manual

Page: 37 / 89

Gearbox
Gear box layout
2 2 3
1 1
dykztf-001
Gear box layout_001
1
Slotted nut 20 and cotter pin for drive
shaft
2
Slotted nut 24 and cotter pin for crank
shaft
3 Gearbox
Removal of gear box
Warning
When removing or installing any crank parts,
be sure to secure the crank.
If the crank is not secured, the crank may
become unbalanced and rotate suddenly.
It may cause injury or death.
The machine is removed from the tractor
with its upper link, up-down handle, and
cover removed.
Remove the upper arms from the left and
right sides of the gear box. (See "Removal
of lower housing Assy" (Page 4-7) .)
Remove the cotter pin from the slotted nut
of the crank shaft. (See "Gear box layout"
(Page 4-15) .)
1
2
3
3
usrzwg-001
Removal of gear box_001
･
1.
2.
1 Gearbox
2 Upper arm
3 Slotted nut and cotter pin
Caution
When removing and installing the crank nuts,
be sure to secure the crank.
Secure the crank bracket by using a wood
block, etc. so that it does not rotate when
the nuts are loosen.
Loosen the cotter nut of the crank shaft.
3
5
1
2
4
usrzwg-002
Removal of gear box_002
1 Crank
2 Wood block
3 Spanner
4 Slotted nut for crank shaft
5 Slotted nut for drive shaft
Remove the cotter pins from the slotted
nuts of the left and right drive shafts. (See
"Gear box layout" (Page 4-15) .)
Caution
When removing and installing the crank nuts,
be sure to secure the crank.
Secure the crank bracket by using a wood
block, etc. so that it does not rotate when
the nuts are loosen.
Loosen the cotter nuts of the left and right
drive shafts.
3.
4.
5.
6.
7.
Operating Machine and Mower Units
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-15
Removal and installation of each section