Baroness TDA1200, Service Manual

Page: 29 / 89

Installation of φ12.φ18 tine mounting board
Caution
Refer to "Tightening torques" (Page 3-4) .
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
Remove foreign matters such as sand on
the contact area of the φ12.φ18 tine
mounting board of the tine holder and in
bolt holes completely.
1
2
3
2orbkg-001
Installation of φ12.φ18 tine mounting board_001
1 Tine holder
2
Contact area of φ12.φ18 tine mounting
board
3 Bolt hole
For installation, reverse the removing
procedure.
Lower housing Assy
Lower housing Assy layout
1 1
g3cyaf-001
Lower housing Assy layout_001
1 Lower housing Assy
1.
2.
Removal of lower housing Assy
Warning
When removing or installing any crank parts,
be sure to secure the crank.
If the crank is not secured, the crank may
become unbalanced and rotate suddenly.
It may cause injury or death.
The machine is removed from the tractor
with its upper link, up-down handle, and
cover removed.
Attach the sling to the crank housing at the
highest point after setting the lower housing
Assy to be removed at the lowest point.
Caution
The purpose is not to lift the main body. Do
not lift it up any more after the crank is
secured.
Lift the sling up by using a hoist, etc., to the
extent that the main body does not lift off
from the ground and then secure the crank
housing.
1
2
mgo9ef-001
Removal of lower housing Assy_001
1 Sling
2 Crank housing
･
1.
2.
Operating Machine and Mower Units
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-7
Removal and installation of each section