LM56/66/18G
7
LM56/66/18G
Installing the LM56/66/18G
Grooved Front Roller Kit
Section
9
Place disc spring washer, Part (12) convex side
up over Part (A).
* Use Part (A), only when installing IGCA.
10
Screw short threaded leg of roller adjustment
screw, Part (9) through Parts (12), (A), (11), and
then into frame. When doing so, align roller
adjuster, Part (10) so that it sits in forked tongue
of the right roller bracket arm. Make sure that
Part (A) is centered then lock and tighten Part
(9) being mindful of the roller adjuster, Part (10)
position.
* Use Part (A), only when installing IGCA.
*Part (11) locates under the Part (A), not shown on this
drawing.
11
Place washer, Part (11) into the cut out slot on
the front of the left frame.
Lift up Roller Part (5), then insert Part (14)
through Bracket Part (2) into frame.
*Use 2 pieces of Part (11) for without IGCA, and 1 piece
of Part (11) for with IGCA version.
12
Fit Part (C) onto Part (14), then insert Part (14)
into left stopper bracket Part (B), as if it places
onto the washer Part (11), then insert Part (11)
and (12) onto Part (14), and screw Part (13)
through Part (14) temporary.
* Use Parts (B) & (C), only when installing IGCA.
