Tire
Inspection of Tires
Check the pneumatic pressure of the tires.
Make sure that there are no cracks,
damage or abnormal wear on the tires.
Tire size
Pneumatic pressure
Front wheel (4.00 - 5)
200 kPa
(
2.0 kgf/
㎝
2
)
Rear wheel 8.50 - 8
80 kPa
(
0.8 kgf/
㎝
2
)
Brake
Inspection of Parking Brake
Make sure that the brake is applied when
you pull the parking brake lever.
Make sure that the brake is not applied
even slightly when you press the push
button to release the parking brake lever.
Inspection of Brake
While traveling, depress the brake pedal until
the pedal hits the pedal stopper to make sure
that the brake is applied effectively.
Clutch
Inspection of Clutch
Operate the clutch levers and check that
the clutch operates perfectly.
Make sure that the clutch levers function
well.
Belt
Inspection of Belt
Warning
The engine must be stopped when the belt is
inspected.
Warning
If you have removed the covers, etc., during
inspection, be sure to securely install them in
their original positions.
If covers, etc., remain removed, the operator
may come in contact with rotating parts or
belts, possibly resulting in injuries.
1.
2.
1.
2.
1.
2.
Important
A slacking or damaged belt may cause the
cutter rotation speed or operation speed to be
insufficient for operation.
Press the middle of the belt with your finger
to check the belt tension.
Make sure that there are no cracks,
damage or abnormal wear.
Wire
Inspection of Wire
Make sure that the wire is not cracked or
damaged.
If the wire is cracked or damaged, replace it
with a new one immediately.
Around The Engine
Inspection around The Engine
Check the fuel system parts for loosened or
cracked joints and leakage. Replace the
parts if necessary.
Blow the air to clean any grass or
flammables attached on or around the
muffler.
Blow air to clean any grass or flammables
attached around the cooling fins or recoil
starter.
1.
2.
1.
2.
1.
2.
3.
LM180C
Handling Instructions
Page 4-4
Inspections
Summary of Contents for LM180C
