19
S
INGLE
R
AMP
& D
WELL
C
ONTROLLER
Note
The program must be stopped and
the controller must be displaying the
actual temperature before beginning
the Setup.
•
The Dwell time can be set by changing the “dwEll”
variable to the desired value. Dwell time units are in
minutes.
•
The program Status can be set by changing the “StAt”
variable to “run” or “oFF.” This variable will start or
stop the program.
Program Setup
1.
Press the SCROLL button until “m-A” is displayed,
then set to “mAn” with the UP or DOWN buttons.
2.
Press the PAGE button once, set the desired Setpoint
temperature with the UP or DOWN buttons.
3.
Press the PAGE button until the “SP” is displayed.
4.
Press the SCROLL button once, “SPrr” (Ramp Rate)
will be displayed, set the desired Ramp rate with the
UP or DOWN buttons, if the ramp to setpoint feature is
needed. If the Ramp rate is not needed, then set to
“OFF” with the UP or DOWN buttons.
5.
Press the SCROLL button once, “tm.OP” (Ramp &
Dwell mode) will be displayed, select the desired
mode with the UP or DOWN buttons. (Opt. 1, Opt. 2,
Opt. 3, Opt. 4, Opt. 5)
6.
Press the SCROLL button once, “dwEll” will be dis-
played, set the desired Dwell time with the UP or
DOWN buttons. (Dwell in minutes.)
7.
Press the PAGE button until the Actual temperature is
displayed.
