Barnes 2ADE11, Installation And Operation Manual

Page: 5 / 20

5
SECTION: A - PUMP SPECIFICATIONS: Wheel Mounted
IMPORTANT !
1.) DO NOT USE FOR PUMPING FLUIDS WITH A FLASH POINT OF LESS THAN 100°F.
2.) MAKE CERTAIN THAT PUMP AND/OR MOTOR ASSEMBLY AND CONTROLS HAVE THE APPROPRIATE RATINGS FOR THE GIVEN APPLICATION
AREA CLASSIFICATION. (ie DIVISION I, AGENCY LISTING ETC.)
2”
3”
inches
(mm)
SUCTION/DISCHARGE:
2ADE-2CDE ....... 2” x 2" NPT
3ADE-3CDE ........ 3” x 3” NPT
LIQUID TEMPERATURE ... 160°F (71°C) Continuous
SUCT/DISCH CHAMBER
ADE ..................... Aluminum, Class 319
CDE ..................... Cast Iron ASTM A-48, Class 30
WATER BOX
ADE .................... Aluminum, Class 319
CDE ..................... Cast Iron ASTM A-48, Class 30
DIAPHRAGM BOTTOM
ADE ..................... Aluminum, Class 319
CDE ..................... Cast Iron ASTM A-48, Class 30
DIAPHRAGM ..................... Thermal Plastic Elastomer (TPE)
BEARING ........................... Ball
FLAP VALVE ...................... Natural Rubber
PAINT .................................
Air Dry Enamel
TRANSMISSION ................ Enclosed, Oil Bath, Double
Reduction
GEAR RATIO ..................... 43:1
OUTPUT STROKES .......... 41 Per Minute
TIRES ................................. 8” x 1.75 (used on ADE & CDE11-1
............................................ ADE & CDE13-1
MOTOR: Design ................. TEFC NEMA B Torque curve,
C-Face, Squirrel cage induction
Insulation ............. Class B
SINGLE PHASE ................. Dual Voltage 115/230
THREE PHASE ................. Dual Voltage 230/460
OPTIONAL EQUIPMENT ... Across the Line Manual Starter