30
1. Removing the bottom plate and the strainer.
After removing the hexagonal nut and the plain washer from the
bottom, remove the bottom plate and the strainer from the pump.
2. Removing the suction cover.
After removing the hexagonal bolt, plain washer, stud bolt and the plain washer, remove
the suction cover and the suction cover packing from the pump.
3. Removing the impeller.
Using a box wrench, remove the impeller nut, hexagonal nut and the impeller thread
protective cover, then remove the impeller and the impeller adjusting washer from the main shaft.
4. Removing the pump casing.
After removing the hexagonal bolt and the spring washer, remove the pump casing, neck
ring, O-ring and the shaft sleeve from the pump.
5. Remove the oil casing if necessary, and remove the mechanical seal.
After removing the hexagonal bolt and the
spring washer, remove the oil casing from the pump. At this time, be careful not to damage the sliding surface of the
mechanical seal. Remove the mechanical seal from the main shaft.
Disassembly procedure for 5 - 20 HP
NOTE
Before disassembling, be sure to drain the oil from the pump.
NOTE
The replacement or maintenance of the mechanical seal must be handled by the qualified staff. If you see
any omissions, contact the dealer from whom you purchased the equipment.
barmesapumps.com
Summary of Contents for KTM Series
Page 42: ......
