PRE-CLEANING CHECKLIST
•
Identify the cases that need to be cleaned (Note: Multiple cases usually run on the same refrig
eration circuit, so plan on cleaning all cases on that circuit at one time)
•
Post safety signs in the area of the cases that are going to be cleaned
•
Remove the product from the cases and relocate to a refrigerated storage area
•
Turn off the refrigeration to the cases, there are several options:
•
Turn off at the power supply
•
If your case is equipped with a clean switch button, push the button. The push button allows for a
90 minute delay and will automatically turn back on after 90 minutes
•
If your case is equipped with a cleaning toggle switch, fl ip the manual toggle off to clean and
manually fl ip back on when case is cleaned
•
If you are unable to turn the refrigeration off to the case by the above methods, put the case in a
manual defrost through the Dixell Controller
Push the DOWN key for more than 2 seconds and a manual defrost will start on the Dixell Con
troller. The controller must be turned back on when fi nished cleaning.
•
If your case is equipped by a different type of controller, refer to the controller manual for putting
the case into manual defrost for case cleaning
•
Turn off the electrical circuits to the case at the power supply
•
Wait until the Coolgenix deck pans are room temperature before removing - the center pan will have
a sensor (Fig. 12) attached on the bottom of the deck pan, detach the sensor before removing the
pan
•
Visually inspect the cases for debris and ice
•
Check the drain to make sure it is not clogged
Before cleaning a Coolgenix case, be certain that all of the steps listed below
have been completed to ensure proper case functionality, safety and compliance
with warranty terms.
CASE CLEANING
22
Summary of Contents for PTD-RGC
Page 2: ...ii ...
