20
5 SOFTWARE SETTINGS
5.1 Tamping cycle counter
1) Turn unit ON and keep in standby mode
2) Hold + button & - button for 3 seconds.
3) Display blinks and shows a number. multiply this number
by 3000, max. cycle counter is 99*3000.
4) Cycle counter disappears after 5 seconds
5.2 Clean cycles counter
1) Turn unit ON and put unit in CLEAN modus (tamper disk
goes down)
2) Hold + button & - button for 3 seconds.
3) Display blinks and shows a number. multiply this number
by 5, max. clean cycle counter is 99*5.
4) Cycle counter disappears after 5 seconds
5.3 20 cycle run-in mode
1) Turn unit OFF. Hold CLEAN button and + button, and turn
unit ON. ‘CF’ appears on display.
2) Push + button
3) Unit start to tamp 20 times as run-in mode to remove any
initial friction in the system
