Barisieur Barisieur Black, Safety Manual, Page: 4 / 73

6 7
EN EN
11. Do not allow the cord to touch hot surfaces and do not place on or
near a hot gas or electric burner or in a heated oven.
12. Keep the cord away from heat and damp.
13. Do not use the Barisieur on a gas or electric cooking top or over or
near an open flame
14. Use of an extension cord with this Barisieur is not recommended.
15. Do not carry the Barisieur by the power cord.
16. If the machine is not working properly or there is some technical
issue switch the machine off and refer to the trouble shooter table. If a
solution cannot be found then contact customer service and return to
an authorised agent.
17. Do not use external automatic timers in conjunction with the
Barisieur.
Operation
INITIAL SET-UP
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5
1. Unpack the Barisieur carefully removing all foam and packaging
away from accessories.
2. Place the unit on a larger surface for more space for set up.
3. Wash all the accessories that will contain water before first use.
4. Place all the accessories in their correct positions as shown in the
diagram above.
5. Plug in the unit to the AC 220-240v mains supply using power cord
provided.
6. The Barisieur must be earthed before switching on.
7. Wait for the display to initiate and display the time and symbols.
8. Remove the bung with transfer tube from the boiling vessel and
fill with water to the MAX line. DO NOT UNDER OR OVER FILL THE
BOILING VESSEL.
9. Place the bung back into the boiling vessel until a positive feeling
snap has occurred. Make sure all protrusions are aligned in the bung
and glass. (Fig 1)
10. Place the boiling vessel back to the wooden tray in the correct
position shown. Make sure all protrusions are aligned on the vessel
bottom and wood. (Fig 2)
11. Put ground coffee or loose-leaf tea in the filter and rotate the filter
arm clockwise so that the filter and funnel are in position above the
cup. (Fig 3)
12. Make sure the transfer tube is aligned and the exit is positioned
over the filter and funnel. (Fig 4)
13. Remove the milk vessel and fill to the MAX line. Snap the bung
back into place to make sure the milk will stay fresh. The cooling
device will not initiate if no milk is present in the vessel as the system
is intelligent and will sense when an opaque fluid is present.
14. Long press (for 3 seconds) the make button in any mode to start
the brewing process.
15. The machine will take approximately 5 minutes depending on
water temperature and environment to finish the brewing process.
(Fig 5)
16. THE BARISIEUR MUST BE AT LEAST 30 CM[DSN3] AWAY FROM
THE BED AND IN A POSITION WHERE IT CANNOT BE ACCIDENTALLY
KNOCKED OVER OR DAMAGED.
WARNINGS