Barikell MK8 90, Instructions For Use Manual

Page: 10 / 32

10
An exact description of the Model and Serial
Number will make it easier for our Technical
Service to respond quickly and efficiently.
Therefore, always indicate the machine model
and serial number when you contact Technical
Service.
3.3. Main parts of the machine and
controls
See Fig. 1
N. Description
1 Right rotor
2 Left rotor
3 Right float adjustment knob
4 Left float adjustment knob
5 Accelerator
6 Protection cage
7 Battery
8 Fuel tank
9 Water tank (Fig. 2)
10 Right control joystick
11 Left control joystick
12 Right headlight
13 Left headlight (Fig.2)
14 Seat
15 Engine
16 Oil tank (Fig.2)
17 Hydraulic pump (Fig.2)
18 Pressure gauge (Fig.2)

NB: For reasons of description the
machine may be represented without the
protection devices. The machine cannot
and must not be operated in these
conditions. At the time of installation, every
precaution must be taken to ensure that
the protection and safety devices are in
place and efficient.
3.4. Seat adjustment
(Fig.3) For horizontal adjustment operate the
lever (4) located under the seat (1), find the
desired position and release the lever (4).
3.5. Blade inclination adjustment
(Fig.4) The blade inclination can be adjusted with
the knobs (1) and (2).
Turn the knob (1) clockwise to increase the blade
inclination of the right rotor ( Fig.1 No.4).
Turn the knob (2) clockwise to increase the blade
inclination of the left rotor ( Fig.1 No.2).
To decrease the inclination turn the knobs
anticlockwise.
3.6. Joysticks
The machine has two joysticks, one on the left-
hand driver’s side (Fig. 5) which executes 2
movements (forward and backward) and one on
the right-hand side, which executes four
movements (forward, backward, right and left).
The machine movements are controlled by a
pressure regulating valve (Fig.7) located in the
lower part of the machine.
3.7. Ambient conditions
The machine should be used sheltered from
atmospheric agents.
The places where the machine is used should be
well ventilated and conform to the regulations in
force regarding hygiene and safety in the
workplace.
•
Do not come close to the machine with
naked flames or similar.
•
Do not use the machine in places
where there is a risk of explosion or
fire.
IMPORTANT : The exhausts contain
carbon monoxide, a hazardous mortal
gas. Do not start the engine in closed or
badly ventilated places.
3.8. Not permitted uses
It is prohibited to employ the machine for uses
different from those expressly indicated by the
manufacturer.
4. Delivery and installation
4.1. Delivery
All the material shipped, including the detached
parts, are checked before delivery.

Upon receipt check that the machine has
arrived intact in all of its parts. If
otherwise, immediately contact our
dealer.
The machine is delivered in a crate weighing
about 370 kg.
Unload it with a forklift truck of adequate capacity
and position it on a stable and horizontal surface.
Remove the top and side packaging and lift the
float machine with a crane using suitable metal
cables hooked onto the attachments (Fig.2 No.10)
arranged on the 4 sides of the cage.
The float machine is shipped fully assembled
except for the seat and the engine-side headlight;
moreover, the two steering levers are lowered and
the battery cable is detached.