• Fig.1
- Using the correct measurements of the fixings for your particular unit e.g. 1000W, 1500W, 2000W, drill 6 holes to suit.
• NOTE
: Before drilling ensure that there are no hidden pipes or wires that will be damaged by the drilling.
• Fig. 2
- Fit two brackets (supplied) to the underside of the unit using the supplied self tapping screws (2 per bracket) as shown. These will hold
the unit off of the wall when hanging.
Operation
•
Comfort Mode: Heater is working on full power.
•
Eco Mode: Heater is working on half power.
•
Anti Frost Mode: Heater turns on if ambient temperature drops below 5
o
C.
Turns off when temperature rises to 7
o
C.
•
Mode Value Selector: Cycle through options to set values.
•
Cycle through modes and increase values set.
•
Cycle through modes and decrease values set.
•
On / Off selection.
•
Control Panel Lock. Press and hold
UP
arrow to engage and press and hold
DOWN
arrow disengage.
•
Heating Icon: Shows when panel is heating.
•
Wireless Icon: Shows when connected.
•
“
h
” Icon: indicates timer has been set.
•
When first powered up the heater will beep, be in standby mode, display the wireless symbol (if connected) and current room temperature.
•
The first time the unit is switched on the Heating and
ECO
icons will illuminate. This means the device is in the
ECO
heating mode state.
The heater has memory function, when you turn on it subsequently, it will be in the last working state and the display will illustrate this.
• To change heating mode, press the
UP
and
DOWN
buttons to cycle through the modes:
ECO
mode, Comfort mode and Anti-frost mode.
• To adjust the set temperature of any of the modes press the Mode Value Selector button and the
LED
displayed value will flash then use the
UP
and DOWN buttons to adjust the temperature. Temperature range is from 5°C –50°C.
• Note: the temperature cannot be adjusted in anti-frost mode.
• To set the timer, press the Mode Value Selector button. When the
LED
displayed value flashes, use the
UP
and
DOWN
buttons to adjust the time.
Timer range is 1 – 24 hours. The digits will flash while setting and then the screen will return to heating mode. The timer icon on the screen will
show that the timer has been set. The heater will heat until the set time has elapsed.
• To set the child lock, press and hold the
UP
button. The Control Panel Lock icon will appear on the screen and the control panel will be locked out.
To release, press and hold the
DOWN
button. The padlock icon will disappear, indicating that all the buttons can be used again.
• To turn off the
LED
display, press and hold the Mode Value Selector button. Press any key to re-light the display screen.
Maintenance
• Always disconnect the appliance and let it completely cool before any maintenance. Use a vacuum cleaner to remove dust on grilles. Clean the
outside of the unit with a damp cloth and then dry it with a dry cloth. Never immerse the unit in water, nor let water drip into the unit.
• Always disconnect the appliance, let it completely cool and clean it before storing. If you do not use the device for a long period, put back the
unit and the instruction manual to the original carton and store in a dry and ventilated place. Do not place any heavy items on top of carton
during storing as this may damage the appliance.
