Barco ZEUS, Installation And Safety Manual

Page: 46 / 189

7. Input & Communication
7.1 Introduction
General
The Input & Communication side of the ZEUS projector consists of a Local Keypad integrated into the projector housing and a card
cage with three slots. The rear side of the projector is equipped with a tail light which re
fl ects the status of the projector.
Depending on the projector con fi guration the projector card cage is equipped with an ICP or ICMP. See illustration below. In case
an ICP is installed then an IMB, IMS, or HDSDI input module can be optionally inserted into the slot below the ICP. Note that all
information about the ICMP is gathered into one separated chapter: "ICMP", page 53.
1
3
2 4 5 6 7
Image 7-1
1
Projector status light.
2 Power ON/OFF switch.
3 Local keypad.
4 Barco Cinema Controller.
5 ICMP.
6 Input slot for IMB, IMS, or HD-SDI input module (in case no ICMP is installed.
7 ICP.
C
AUTION
:
A unit may only be removed from the card cage by quali fi ed service personnel. Removing one of
the boards (except for the Cinema Controller) will result in an authorization request upon starting.
42 R5905961 ZEUS 09/03/2015