Barco XDL, Installation Manual

Page: 42 / 88

R5906150 /05 XDL 42
Order No
Type Throw Range (4K)
R9856300 HB 1.65 - 2.60
R9856303 HB 2.00 - 3.35
4.7 Lens selection
How to select the right lens
1. Determine the required screen width (SW).
2. Determine the approximate position of the projector in the room.
3. Start up the Lens Calculator on the Barco website: https://lenscalculator.barco.com/ to determine the
possible lenses for your configuration.
The Lens Calculator window opens.
Image 4 – 10 Lens calculator
The Lens Calculator can also be used to determine the position of the projector when the lens type
and screen width is known.
Due to lens tolerances the results of calculated values may be different from measured values.
These difference may vary +/- 5%.
4.8 Removing the projector feet
When trying to tilt the projector in an angle beyond what the projector feet can handle, use an
external frame that achieves this angle instead.
Take into account that when using an external frame, the projector feet must be removed
completely and the holes must be used to attach the projector to the rigging frame (using screws of
M16 x 200).
Required tools
• Open end wrench 17 mm
• Open end wrench 24 mm
Installation preparations