Barco XDL, Installation Manual

Page: 29 / 88

29 R5906150 /05 XDL
5. Electrical connection with the power net. See chapter. For detailed info and possibilities see chapters:
• “ Accessing the mains compartment ” , page 50
• “ Connecting the external safety interlocks ” , page 51
• “ Three phase power input configuration of the projector ” , page 52
• “ Connecting the projector with the mains electricity ” , page 54
• “ Power loop through to the projector electronics ” , page 55
6. Install the batteries of the Remote Control Unit (RCU). See chapter “ Remote control, battery installation ” ,
page 46 .
7. Installation of the Projector Toolset on local laptop. Download and install the latest version from the Barco
website. See chapter
“ Download Projector Toolset ” , page 43 .
8. Switch on the projector and start image projection. See user guide of the projector for details on how to
operate the projector. Following options are possible to control the projector:
• using the RCU
-
Remotely. Ensure that the RCU address matches the projector individual address for the IR
receivers. For details see chapters:
◦ “ Displaying and Programming addresses into the RCU ” , page 61 .
◦ “ Setting the projector addresses ” , page 62 .
- Hard wired. RCU with XLR cable connected. See “ Using the XLR connector of the RCU ” , page 62
• using the Local Keypad.
• using Projector Toolset. See manual of the Projector Toolset.
9. Alignment of the projected image with the screen. Activate an internal test pattern to focus, zoom and shift
the lens until the projected image is aligned with the screen. Use for that the:
• Focus, Zoom and Shift buttons of the RCU.
• Lens adjustment button of the Local Keypad. For detailed instructions see user guide of the projector.
• Projector Toolset control software. For detailed instructions see user guide of Projector Toolset.
To level the projector with the screen adjust the feed of the projector in case of a table mount installation
(see
“ Alignment of a table mounted projector ” , page 63 ), or adjust the rotation of the external frame in case
of a suspended installation.
10. If needed change the projector orientation (e.g. Front/Table, Front/Ceiling, Rear/Table, Rear Ceiling). See
user guide of the projector for the software settings of the projector orientation.
11. Check for the latest projector software package. See chapter “ Software update ” , page 66 .
3.3 Additional install options
Overview
1. Installation of an optional input board (e.g. Quad DP 1.2 input or the SFP input ) or replacing an input
board.
• for removal see “ Removal of an input board ” , page 65 .
• for installation see “ Installation of an input board ” , page 64 .
• for configuring the SFP input see “ Pulse SFP input use cases ” , page 69 .
2. Installation of the WiFi & GSM module. For installation instructions see installation manual of the WiFi &
GSM module.
Installation process