Power Connection
6-1
5976026A BARCOVISION 708 200499
6
POWER CONNECTION
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall
outlet. Plug the female power connector into the male connector at
the front of the projector.
Input power (mains) voltage adaptation.
Attention
The BARCOVISION 708 - R9002351/52 leaves the factory to operate
on a mains (power) input of 230 Vac.
Adaptation of the power input of the projector from 230 VAC to 120
VAC or vice versa is possible. Follow the procedure as described
below.
Procedure
- Unplug the power cord from the power input on the front panel.
- Loosen the 2 retaining screws of the front panel.
- Pull out the module.
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF
ON
Summary of Contents for Vision 708 9002357
