Barco ULTRA REALITY 7000 R9002810, Owner'S Manual

Page: 19 / 99

3. Connections
What can be connected to the Video input?
Composite video signals from a VCR, OFF air signal decoder, etc... No loop through.
How to connect a Video source.
1. Connect the video output of your source to the video input of the projector (slot 3). 1 x BNC or cinch 1.0Vpp ± 3 dB. (image 3-3)
Note: No loop through available.
SDI SDO
S-VIDEO
VIDEO
R G B V
7
2
4 3
10Base-T
G/Y B/PB H/C V
1
HDSDI
HDSDO 9
RS 232 IN
RS 232 OUT
RC
DVI
H/C
R/PR
95
Image 3-3
How to select slot 3
1. Key in 3 on the RCU or the local keypad or use the menu
The cinch connector and the BNC connector are internaly connected together.
A video signal can also be connected on the 5 cable input (BNC1)
3.1.5 S-Video input
What can be connected?
Separate Y-luma/C-chroma signals for higher quality playback of Super VHS-signals.
How to connect the S-Video signal.
1. Connect the S-video output of your source to the S-video input of the projector (slot 4)
Pin configuration of the mini DIN plug.
1 ground luminance
2 ground chrominance
3 luminance 1.0Vpp ± 3dB
4 chrominance 282 mVpp ± 3dB
How to select slot 4?
1. Key in 4 on the RCU or the local keypad or use the menu (image 3-4)
R5976455 BARCO ULTRA REALITY 7000 30062003 15