![background image](http://html1.mh-extra.com/html/barco/udm-w22/udm-w22_quick-reference-manual_4258006004.webp)
2. Orientation
of the unit is set as standard in table front projection mode.
Change the projector set up in the INSTALLATION > ORIENTATION menu.
3. For Advanced adustments
like Warping, Light management, etc. see projector User Guide.
1. Adjust the lens settings
by pressing the lens menu button on the keypad or via the zoom,
shift and focus buttons on the RCU.
1. Press the Power on/off button
for three seconds.
2. Wait until the after-cooling cycle is finished
(approximately 5 minutes).
3. Turn the mains switch to off
(’0’).
4. Unplug the power cord
from the projector.
Adjust
Switch off
Precautions
- Remove the lens before transporting the projector.
- Switch the projector to standby mode and wait until the after-cooling
cycle is finished before switching off the main power.
- Ensure the projector is operating with clean filters.
- Do not block the ventilation in and outlets of the projector and chiller
(if used).
- External laser light can cause severe damage to the DMD. This damage
is not covered by warranty.
1
2
3
4
3 sec
5 min
Please allow the projector to cool down properly as this will positively impact the lifetime
of its components.
Note