CHAPTER 6
General Maintenance
Technospot
TM
User Manual
55
3. Adjust the focus until the edge of the light beam is sharp.
4. Set the Dimmer to full (DMX = 255)
5. Locate the three lamp optimization screws (a, b, and c).
6. Look at the wall where the beam is projected and use the
optimization screws to adjust the lamp’s position within the
fixture until the “hotspot” of brightness is at the center of
the beam and diffused.
Replacing Main Fuse
To replace the fuse:
1. Disconnect power to the fixture. If the fixture has been operating, allow the fixture to cool
before handling.
2. Locate the fuse on the connection panel of the fixture’s electronic housing.
3. Replace with a fuse of the same type and rating, see
Related Products and Accessories
on
page 5.
Lamp
Adjustment Screws
CHAPTER 6
General Maintenance
Technospot
TM
User Manual
55
3. Adjust the focus until the edge of the light beam is sharp.
4. Set the Dimmer to full (DMX = 255)
5. Locate the three lamp optimization screws (a, b, and c).
6. Look at the wall where the beam is projected and use the
optimization screws to adjust the lamp’s position within the
fixture until the “hotspot” of brightness is at the center of
the beam and diffused.
Replacing Main Fuse
To replace the fuse:
1. Disconnect power to the fixture. If the fixture has been operating, allow the fixture to cool
before handling.
2. Locate the fuse on the connection panel of the fixture’s electronic housing.
3. Replace with a fuse of the same type and rating, see
Related Products and Accessories
on
page 5.
Lamp
Adjustment Screws
