![background image](http://html1.mh-extra.com/html/barco/sim-7qp-hb/sim-7qp-hb_user-manual_4252429054.webp)
6. Getting started
6.3
Adjusting the image
How to adjust the image ?
1. Use the Image setting buttons on the RCU
AUT
AUTO IMAGE
O IMAGE
PC
PC
RGB
RGB
VIDEO
VIDEO
Fire W
Fire Wire
ire
DVI
DVI
IQ-PC
IQ-PC
SDI
SDI
S-VIDEO
S-VIDEO
PHASE
PHASE
TINT
TINT
COLOR
COLOR
BRIGHTN
BRIGHTN
CONTR
CONTR
ZOOM
ZOOM
DIGI
DIGI
9
0
7
8
5
6
3
4
1
2
Image 6-3
6.4
Switching the projector to standby
Introduction
If the projector is not to be used for a period of time (hours, days), it is advised to switch it to
standby
to save energy or it can be
fully powered off after the cooling cycle. The advantage of standby mode compared to power off mode is the time to get it back to
active state (i.e. lamp on).
After switching the projector to standby, the lamp is switched off and the
cooling cycle
is started (two minutes). Do not power off
the projector during the cooling cycle since doing so reduces the lamp life time.
In case of SIM 7QP HB or SIM 7QP HB&C, the projector cannot be switched from active state to standby state within the
fi
rst two
minutes after it has been activated. Trying to do so pops up an alert message and the command is only executed after the two
minutes period has expired.
Image 6-4
Switching to standby
1. While the projector is in active state, keep the
Standby
button on the RCU or on the local keypad pressed for two seconds.
2. The lamp is switched off and the two minute cooling cycle is started.
50
R59770330 SIM 7QP SERIES 08/12/2014
Summary of Contents for SIM 7QP HB
