BARCO 8
Projection Systems
Mounting the control module
What has to be
done
The module has to be mounted in the convergence drawer
Necessary Tools
flat screwdriver
Mounting the
To mount the print, follow the next procedure:
1
2
3
4
5
6
7
1
2
3
3
4
5&6
7
Release the two handles of the drawer by pushing as
shown on the image
Pull the drawer ou of its housing
Place the print as shown on the image
Tighten the print with the 4 delivered screws.
Use the shortest yellow cable (7P) to connect the module
to the controller located as shown on the image.
Use the longest yellow cable (3P) to connect the print to
the Convergence module located as shown on the image
(connector A on image 6)
Use the cable with the BNC connectors to connect the
module (DIN connector side) to the motor (BNCs side)
Step
Action
Image
Illustrations
Image 2
Image 3
A
Image 1
