Barco R9840060, Installation Manual

Page: 2 / 4

BARCO ——————————————————— 1 ————————————— Projection Systems
QGD(3.4-4.5:1) Lens R9840060
What has to be
done
This new lens has to be installed on a 6000 series projector
Necessary Tools no tool necessary
Installing the
Lens
To install the lens, follow the next procedure or look into the owner’s manual :
1
2
3
4
5
6
7
8
9
10
1
1
2
2
3
3
3
Take the lens out of its packing material.
Open the lens cover of the projector.
Loosen the wing bolts (B) and pivote the motor part (A) up.
Open both lens locks (C) by pulling them backwards.
Put the lens on the lens holder.
Fix the lens by closing both locks (C) until they are se-
cured.
Pivote the motor part (A) fully downwards.
While pushing down, tighten wing bolts (B) firmly to ensure
good functioning of safety latches.
Plug the motor wires into the free socket on the motor part
(A).
Re-install the lens cover.
Step Action Image
To be continued on next page.
Warning ! Risk of personal injury. Instructions for lens installation must be followed thoroughly.
Attention The motor part (A) (image 3 on next page) should be equipped with an extra socket to
plug in the motor connections of the lens. If the motor part is not equipped with this
extra socket, contact a Barco service center.