Barco R9004120, Owner'S Manual

Page: 80 / 105

12. Advanced Settings
12.8.2 Backlight
About backlight
The backlight function can be used to adjust the display brightness for the different environment conditions. E.g. when installed in
an environment with a lot of light the backlight should be increased.
How to change the backlight ?
1. Select
Advanced Settings
.
2. Press ENTER to activate.
The
Advanced Settings
menu will be displayed. (menu 12-21)
3. Select
Display Settings
.
4. Press ENTER to activate.
The
Display settings
menu will be displayed. (menu 12-22)
5. Select
Backlight
.
6. Press ENTER to activate.
A slider bar will be displayed with the actual backlight level filled out.
7. Use ↑ or ↓ to adjust the backlight level to desired level.
Advanced Settings
Gamma
Color Temperature
Input Balance
Noise Reduction
Film mode detection [ON]
Video AGC
Display Settings
Installation
Service
Back
Menu 12-21
Display Settings
Rotate : landscape
Backlight
Back
Menu 12-22
12.9 Installation
Overview
• File Services
• When no Signal
• Language Selection
• Tiled setup
12.9.1 File Services
12.9.1.1 Introduction to image files
Introduction
An image file contains the main characteristics of a source (number of active lines,...). The displays’s memory contains a list of files
corresponding to the most common sources, these are the standard files (file extension= *.s). When a new source corresponds to
one of these files, a custom file (file extension=*.C) is created and saved for future use.
The maximum number of custom files that can be created is 63, the four last files are systematically overwritten.
When there is a little difference, the file can also be loaded and then edited until the source specs are reached.
The Load Automatic function creates automatically the best suited image file (custom file) for a new source.
76 R5976672 SOLARIS LC40 01042004