Barco R9004120, Owner'S Manual

Page: 38 / 105

5. Getting Started
Treble Treble control adjusts the treble level (high tones).
Use the + button for more high tones.
Use the - button for less high tones.
Balance Is only effective if a external amplifier with loudspeakers is connected to the audio output. The balance
control adjust the sound level between the left and the right box.
Use the + button for a higher sound level on the right box than on the left one.
Use the - button for a higher sound level on the left box than on the right one.
The Pause Key
When the Pause key is pressed, the display is blanked.
To redisplay the image:
•
Press PAUSE key
5.5 Locking the Solaris LC40 for IR signals
What is possible ?
The Solaris LC40 can be locked for any IR signal. When locked, IR signals send to the display will be ignored by the display.
Unlocking is possible via the remote control by entering a 4 digit PIN code. The default factory PIN code is “0000”.
This default PIN code or any other entered PIN code can be changed at anytime, see "Changing your PIN code", page 84
How to lock ?
1. Press ENTER on the RCU or press the thumb wheel once.
The main menu will be displayed. (menu 5-2)
2. Select
Service
and press ENTER or the thumb wheel.
The service menu will be displayed. (menu 5-3)
3. Select
IR locking
and press ENTER .
The
IR locking
menu will be displayed. (menu 5-4)
4. Select
Locking [off]
and press ENTER to toggle to [on].
As you cannot use the back button anymore, the menu will disappear after a few seconds.
Your display is locked for IR signals.
Solaris LC40
Select input
Image settings
Audio settings
PiP settings
Compact PC Control
Advanced settings
Standby
Back
Menu 5-2
Service
Identification
IR address : 004
Serial communication
IR locking
Restore factory defaults
Back
Menu 5-3
IR locking
Enter key
Locking : [off]
Back
Menu 5-4
How to unlock ?
1. Point your RCU to the display and enter the 4 digit PIN code with the digit keys on the RCU.
When your PIN code is correct, all functions are accessible.
5.6 Quick access to Picture in Picture
Quick PiP source selection
Before selecting the source number (between 1 and 8) enter first 9, immediately followed by the source number.
34 R5976672 SOLARIS LC40 01042004