Barco R9002380, Installation Manual

Page: 23 / 37

Power Connection
5-1
5976067 BARCOCINE 7 151299
5
POWER CONNECTION
Power Connection
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front of the projector.
Input power (mains) voltage adaptation.
The BARCOCINE 7 - R9002380/81/82 leaves the factory to operate on a mains (power) input of 230 Vac.
The BARCOCINE 7 - R9002387/88/89 leaves the factory to operate on a mains (power) input of 120 Vac.
Adaptation of the power input of the projector from 230 VAC to 120 VAC or vice versa is possible. Follow the procedure as described
below.
1. Unplug the power cord from the power input on the front panel.
2. Loosen the 2 retaining screws of the front panel (image 1).
3. Pull out the module.
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF ON
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
OFF ON
See installation instructions before
connecting to the supply
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
image 1
image 1