Unpacking & Dimensions
2-4
5975288A BARCOGRAPHICS 8200LC 150597
Unpacking & Dimensions
2-4
5975288A BARCOGRAPHICS 8200LC 150597
Battery installation in the RCU.
A battery is delivered inside the plastic bag with the power cord. To install the battery, remove the battery
cover on the backside of the remote control by pushing the indicated handle a little to the bottom of the
RCU. Lift up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type E-block or equivalent) in the lower compartment and connect the battery
to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Note : projector address has to be programmed on the RCU before using the RCU (see chapter
'Controlling').
fig.1
310a.DRW
fig.2
Insert here the 'Insert card
RCU' which you can cut out
on the last page of this
manual.
Contact
plate
Battery
Battery installation in the RCU.
A battery is delivered inside the plastic bag with the power cord. To install the battery, remove the battery
cover on the backside of the remote control by pushing the indicated handle a little to the bottom of the
RCU. Lift up the top side of the cover at the same time (fig. 1).
Insert the new 9 V battery (type E-block or equivalent) in the lower compartment and connect the battery
to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Note : projector address has to be programmed on the RCU before using the RCU (see chapter
'Controlling').
fig.1
310a.DRW
fig.2
Insert here the 'Insert card
RCU' which you can cut out
on the last page of this
manual.
Contact
plate
Battery