Service Mode
5975288A BARCOGRAPHICS 8200LC 150597
1 3 - 7
Service Mode
5975288A BARCOGRAPHICS 8200LC 150597
1 3 - 7
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OUT
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
I R- A CK NO WL E DG E D
I R-RE CE IV E D
DI AG NO STICS
CO DE
I R- RECE I V E R
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OUT
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
I R- A CK NO WL E DG E D
I R- RECE I V E D
DI AG NO STICS
CO DE
I R-RE CE IV E R
Loosen the locking
screws.
Open the top cover
Change Password
This item is password protected when the password strap is installed.
How to enable or disable the password function ?
The password function is enabled when the password strap on the
controller module is installed.
To gain acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver or coin
counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly and
lay it down on the second part of the top cover.
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OUT
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
I R- A CK NO WL E DG E D
I R-RE CE IV E D
DI AG NO STICS
CO DE
I R- RECE I V E R
R
B
V
R
B
V
100 - 230 V
9 - 4 A
60 - 50 Hz
RS232 OUT
0
I
This device complies with Part 15 of the FCC rules. Operation
is subject to following two conditions :
(1) This device may not cause harmful interference
(2) This device must accept any interference received
including interference that may cause undesired operation
I R- A CK NO WL E DG E D
I R- RECE I V E D
DI AG NO STICS
CO DE
I R-RE CE IV E R
Loosen the locking
screws.
Open the top cover
Change Password
This item is password protected when the password strap is installed.
How to enable or disable the password function ?
The password function is enabled when the password strap on the
controller module is installed.
To gain acces to the controller module, handle as follows :
- Power down the projector and disconnect the power cord from the
wall outlet.
- Turn both lock screws of the front top cover with a screwdriver or coin
counter clockwise.
- Lift up and pivot the top cover. Attention : the cover is not secured
with an incorporated support. When opening, turn it over slowly and
lay it down on the second part of the top cover.
