Messages, warnings and failure codes
8-1
5976283 BARCORAPHICS 808s 160501
8
MESSAGES, WARNINGS AND FAILURE CODES
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
SOURCE 01
Fh= 15.6 kHz
Fv= 050 Hz
Announcement of the selected
source.
e n t e r
password
xxxx
Message to enter your pass-
word. Password contains 4
digits.
text on
text off
These messages will be dis-
played on the screen when push-
ing the
<TEXT> key.
Text ON : the
'bar scale indica-
tion'
will be enabled during the
change of an analog control in
the
'operational mode'
+ all warn-
ings and failures will be dis-
played.
Text OFF : the
'bar scale indica-
tion'
will be disabled during the
change of an analog control in
the
'operational mode'
+ all warn-
ings and failures will not be dis-
played.
PROJECTOR
ADDRESS :
003
Indication of the projector ad-
dress when activating the
'AD-
DRESS'
button on the RCU with
a pencil or other small object.
WARNING :
input not
available
When using the projector with
the RCVDS, this warning will be
displayed when selecting an in-
put slot of an RCVDS where the
input board is missing.
When selecting a new source,
information about this source
will be displayed on the screen.
Source number, horizontal and
vertical frequencies of the dis-
played source.
WARNING :
source not
available
The input is a valid input but the
source is not connected to the
input terminals or the input source
is switched off.
WARNING :
invalid
key entry
When a wrong key is pressed on
the RCU.
WARNING :
invalid
code entry
Message when the entered
password is wrong.
WARNING :
end of ad-
just range
End of adjustment range.
WARNING :
input no
longer
available
Message will be displayed when
the input source is no longer
available. The following message
then appears:
'check input sig-
nal or select new source'.
This message will be displayed
after the message
'input no
longer available'
. It asks to check
the connections between the
source and the projector or to
check if the source is switched
on.
check input signal
or select
new source
WARNING :
input selector
not
available
It warns you to check the power
connection or the power status
of the RCVDS.
Next message will appear imme-
diately on the screen :
'go to
stand-by'.
