Barco MDSC-2242, User Manual, Page: 38 / 64

K5903030 (451920611336) /05 MDSC-2242
38
To activate auto adjustment
1. Bring up the OSD main menu.
2. Navigate to the Picture advanced menu.
3. Enter the Auto Adjustment submenu.
The automatic picture adjustment is activated: the phase and clock per line parameters are automatically
adjusted.
5.2.5 Phase
This menu item is only available when VGA input is connected.
About phase
If the result of the Auto Adjustment procedure described above isn ’ t satisfactory, the Phase can be manually
adjusted by following this procedure.
To manually adjust the phase
1. Bring up the OSD main menu.
2. Navigate to the Picture advanced menu.
3. Enter the Phase submenu.
The command bar Phase is highlighted.
4. Set the phase as desired and confirm.
5.2.6 Clock/Line
This menu item is only available when VGA input is connected.
About clock/line
If the result of the Auto Adjustment procedure described above isn ’ t satisfactory, the Clock/Line can be
manually adjusted by following this procedure.
To manually adjust the phase
1. Bring up the OSD main menu.
2. Navigate to the Picture advanced menu.
3. Enter the Clock/Line submenu.
The command bar Clock/Line is highlighted.
4. Set the clock/line as desired and confirm.
5.3 Display Format menu
Overview
•
Main Source (Primary Source)
•
Component Mode
•
Zoom
•
Image Size
•
2 nd Picture Mode
Advanced operation