Barco MDRC Series, User Manual

Page: 22 / 55

22
Start Your Installation
Connecting the Display
Use only the power adapter, power cord, and the video cable shipped
with this display. For MDRC-1119 :The universal external 12V DC/ 5.0A
power adapter (100-240V~, 1.5A, 50-60Hz for power adapter rating) is
the AULT (JMW160KB1200F04). For MDRC-2120, the universal external
24V DC/ 2.7A power adapter (100-240V~, 1.5A, 50-60Hz for power
adapter rating) is the AULT (JMW160KA2400F04)
To setup this display, please refer to the following figure and
procedures.
1. Be sure all equipment is turned off.
2.
Connect the DC power cord to the power connector; plug one
end of the AC power cord into the power adapter, and the
other end into an electrical outlet. (
1).
3. For a PC with Analog output: Connect the VGA signal cable
from display VGA input connector to the 15-pin connector of
your host computer and tighten the screws. (
2).
4. For a PC with DVI digital output: Connect the DVI signal cable
to the connector of the display card in your computer, connect
the other side to the DVI-D input port of your display. Tighten
the screws (
3).
5. Turn on your computer, display and video source.
Note: To ensure the LCD Display will work well with your computer,
please configure the display mode of your graphics card to make it less
than or equal to the native resolution, and make sure the timing of the
display mode is compatible with the LCD screen. We have listed the
“Compatibility Modes” of this LCD screen in appendices for your
reference.