Barco ICP-D, Installation Manual

Page: 22 / 54

R5912083 /01 ICP-D 22
3.3 Installing the ICP-D
How to install the ICP-D into the Card Cage
1. Gently insert the ICP-D in the guides of the Card Cage as illustrated below.
Caution: Ensure that the both sides of the ICP-D are captured by the guides inside the Card
Cage compartment. See detail in image below.
Caution: Ensure that the slot located under the ICP-D is empty during this procedure. For
mechanical reasons the ICP-D board cannot be manipulated (removal/installation) when the 3rd
party IMB board (or some metal partition plate) is still inserted.
2. Push (apply a little pressure) on both handles until the ICP-D is fully inserted and the connection is made
with the back plane.
Note: All connections are made via the board to board connection with the back plane.
3. Use a PH2 Phillips screwdriver to fasten two screws located on the ICP-D front side (reference 1 and
reference 2).
ICP-D installation in card cage of projector:
1
2
Image 3 – 1
4. Depending on the projector type the input cover of the projector has to be installed. Flat screwdriver may
be needed for this action. For detailed instructions see User & Installation manual of the projector.
5. Reconnect the power cord and switch on the projector.
ICP-D installation