Barco HDF W22, Installation Manual

Page: 57 / 381

4. Input & Communication
RS422
An EIA serial digital interface standard that speci fi es the electrical characteristics of balanced (differential) voltage,
digital interface circuits. This standard is usable over longer distances than RS-232. This signal governs the asyn-
chronous transmission of computer data at speeds of up to 920,000 bits per second. It is also used as the serial port
standard for Macintosh computers. When the difference between the 2 lines is < - 0.2V that equals with a logical ’0’.
When the difference is > +0.2V that equals to a logical ’1’..
USB port
The communication interface is equipped with a master USB port, type “A” connector. This USB port will simplify the service pro-
cedures for software updates or for taking backup
fi les from the projector without network connection. An USB-stick is plugged into
the USB port and fi les can be transferred from or to the projector using the local or remote control unit. Note that the USB-stick has
to be Linux FAT16 compatible.
Ethernet port
The projector can be connected to a LAN (local area network) using the Ethernet port on the communication interface. Once con-
nected to the LAN, users are capable of accessing the projector from any location, inside or outside (if allowed) their company
network using the control software: Projector Toolset. This toolset locates the projector on the network in case there is a DHCP
server or the user can insert the correct IP-address of the projector to access the projector. Once accessed, it is possible to check
and manipulate all the projector settings. Remote diagnostics, control and monitoring of the projector can then become a daily and
very simple operation. The network connectivity permits to detect potential errors and consequently improve the time to servicing.
The connector used for the Ethernet ports (E) are of rugged Neutrik EtherCon RJ45 type, which is compatible
with standard RJ45 cable connector. Straight (most common) as well as cross linked network cables can be
used.
10/100 Base-T — RJ45 port
Pin Description
1 TXD+
2 TXD-
3 RXD+
4
—
5
—
6 RXD-
7
—
8
—
Status lights
Function
Color
Description
ETH act
green
When connected with an Ethernet
10/100
orange
When a 100 MB network is detected
IR red IR received but not acknowledged
green
IR received and acknowledged
WIFI sel
orange
When WiFi is selected
ACT
green
When WiFi is connected with an Ethernet
ERR red See "Status LEDs", page 64.
PWR
orange
See "Status LEDs", page 64.
LMP
orange
See "Status LEDs", page 64.
R5905158 HDF W SERIES 01/06/2012 53