Barco Galaxy WARP 7 HC, Owner'S Manual

Page: 46 / 154

5. Getting Started
5.6 Controlling the Projector
Overview
• Common Address
• Projector Address
• RCU Address
• Input Selection
• Picture Controls
• Menus on Local LCD Display
5.6.1 Common Address
What is Common Address 0?
Every projector has a Common Address default set to ’0’, when the RCU is set to address ’0’, every projector, without exception will
listen to the commands given by this RCU.
When to use Common Address 0?
• Since the RCU is default set to address ’0’, this is used by default to control the projector in a single projector setup.
• The Common Address is used to control multiple projectors using only a single RCU.
When to use Common Address 1?
Most RCU’s used by other electronic equipment are set to address ’0’, to disable the interference of other RCU’s the Common
Address of the projector(s) can be set to ’1’. When the projector’s RCU is set to address ’1’, every projector, without exception will
listen to the commands given by this RCU.
How to set the Common Address?
See ’Change Common Address’ in the chapter ’Service Mode’.
5.6.2 Projector Address
When to use the Projector Address?
To control a separate projector in a multiple projector setup.
What is the Projector Address?
Each projector can be set to an individual Projector Address, this can be set between ’0’ and ’255’.
Projector Address Controlled by
0–9 RCU
0–255 Computer (IBM PC or compatible, Apple, ...)
Regardless of the Projector Address, the projector will still respond to a RCU set to address ’0’ or ’1’ through
the Common Address.
How to set the Projector Address?
See ’Change Projector Address’ in chapter ’Service Mode’.
5.6.3 RCU Address
The RCU Address can be any digit between ’0’ and ’9’.
42 R5976755 BARCO GALAXY WARP™ 7 HC 05/04/2004