Barco Galaxy WARP 7 HC, Owner'S Manual

Page: 27 / 154

4. Connections
Pin 9 TMDS DATA1- Pin 21 TMDS DATA5+
Pin 10 TMDS DATA1+ Pin 22 TMDS Clock Shield
Pin 11 TMDS DATA1/3 Shield Pin 23 TMDS Clock+
Pin 12 TMDS DATA3- Pin 24 TMDS Clock-
How to select DVI on Input 2?
1. Press the
2
key on the RCU or Local Keypad.
4.5.4 Inputs via RCVDS05
Overview
When using a RCVDS05, the input configuration must be as follows:
Slot 1 RGB/Component
Slot 2 Not Used
When using a RCVDS05, it is recommended to use a 5-cable output module in the RCVDS. The outputs of this module has to be
connected to slot 1 of the projector.
4.6 Communication Connections
Overview
• Linked System
• RS232 (RS422) connection
• Communication with peripherals
4.6.1 Linked System
C
AUTION
:
Always use the Barco COM 800 Splitter, R9827941 (240V) or R9827948 (110V), when using the COM
800 protocol.
What can be done?
In a complex multi-channel setup, projectors can be controlled using the RS232 or COM800 Protocol.
CLO and Dynacolor™ can be controlled by both protocols, however by using the COM800 port for these 2 adjustments, the RS232
Port can still be used for general RS232 commands.
The following procedures will describe how to connect a RS232 Linked System and a COM800 Linked System.
How to connect a RS232 Setup?
1. Connect a Null Modem connector to the RS232 Input of the master–projector. (image 4-4)
2. Connect the output of the Null Modem connector to the RS232 Input of the first slave–projector (image 4-4).
3. Continue by connecting the RS232 Output of the first slave-projector to the RS232 Input of the second slave–projector (im-
age 4-4).
4. Continue this daisy chain connection to connect all slave–projectors (image 4-4).
R5976755 BARCO GALAXY WARP™ 7 HC 05/04/2004 23