Barco Galaxy WARP 7 HC, Owner'S Manual

Page: 31 / 154

4. Connections
4.6.2 RS232 (RS422) connection
Application
1. Remote control:
- easy adjustment of projector via an IBM PC (or compatible) or MAC connection.
- allow storage of multiple projector configurations and set ups.
- wide range of control possibilities.
- address range from 0 to 255.
2. Data communications: sending data to the projector or copying the data from the projector to a hard memory device (hard disc,
floppy, etc.).
4.6.3 Communication with peripherals
What is possible with an RCVDS05 connected.
• Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS’s are linked via the expansion module.
• Serial communication with the projector.
• Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
• The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED
on the rear.
For more information about the use of the RCVDS05, consult the owner’s manual of the RCVDS05.
What is possible with an VS05 connected.
The VS05 can switch up to 5 Composite Video sources, 3 Super Video sources and 1 RGB analog or component video source to
the projector. In addition, the audio signal proper to the source, can be switched to an audio amplifier. Order number : R9827890
For more information about the use of the VS05, consult the VS05 owner’s manual.
Connecting an IR Remote Receiver to the projector.
This infrared receiver unit makes it possible to control the projector from another room. There is a communication line cable between
the IR receiver and the projector or the RCVDS. The control information from the RCU can now be sent to the IR Remote Receiver.
The IR Remote Receiver displays the selected source on a 7-segment display.
4.7 Stereo Connections
4.7.1 Single Channel Stereo Connections
4.7.1.1 Left/Right Phasing Module (Input 3)
Purpose
The Left/Right Phasing module allows us to manipulate the Stereo Emitter Signal that activate the Stereo Glasses.
How to connect the stereo emitter signal?
1. Connect the stereo emitter signal from the Image Generator to the Mini DIN input of the Left/Right Phasing module. (image 4-7)
Note: On some IG’s, the Stereo Sync is already present in the Vertical Sync Signal.
2. Connect the IR emitters to the BNC output(s) of the Left/Right Phasing module.
R5976755 BARCO GALAXY WARP™ 7 HC 05/04/2004 27