Barco Galaxy WARP 7 HC, Owner'S Manual

Page: 32 / 154

4. Connections
High Bandwidth RGB INPUT
DVI INPUT
L/R SIGNAL Phased L/R SIGNAL
Two Way
hardwired
remote
Hardwired
remote
Hardwired
remote
10(/100)BASE-T RS 232/422 IN RS 232/422 OUT COMM PORT
Read instructionsbefore
connecting periphals
Sync OK IR
Green operational
Red Stand-by
IR-Reciever Diagnostic Code
IN OUT
G R B H/C V
CTRL 3 CTRL 2
CTRL 1
Image Generator
IR Emitter
Active Glasses
IR Emitter
Image 4-7
Left/Right phasing module connections
4.7.2 Multi-Channel Stereo Connections
Overview
• Stereo Set Up
• Single CADWall Configuration
• Multiple CADWall (Showroom Installation)
4.7.2.1 Stereo Set Up
How to Set Up the Stereo Parameters?
The Transport Delay Setting must be the same on all Projectors.
The Stereo Phase must be same on all projectors, first adjust the Stereo phase on the projector where the IR Emitter signal comes
from, then put the same value on the other projectors as well.
For more detailed information on how to adjust these parameters (see "Stereo Options", page 111).
For more detailed information on synchronous /asynchronous mode (see "Forced Asynchronous", page 117).
28 R5976755 BARCO GALAXY WARP™ 7 HC 05/04/2004