Barco GALAXY R9040310, Owner'S Manual

Page: 72 / 97

9. Installation Mode
How to change ?
To set up the shutdown time, handle as follow:
1. Push the cursor key
↑
or
↓
to highlight No Signal . (menu 9-15)
2. Press ENTER to select.
The no signal menu will be displayed. (menu 9-16)
3. Push the cursor key
↑
or
↓
to highlight Shutdown Time .menu 9-16
4. Push the cursor key
↑
or
↓
to change the digits.
Or,
Enter the digits directly with the digit keys on the RCU.
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
SOURCE SWITCHING
NO SIGNAL
CONVERGENCE
CONFIGURATION
LENS
QUICK ACCESS KEYS
OSD
INTERNAL PATTERNS
Select with
↑
or
↓
then <ENTER>
<EXIT> to return.
Menu 9-15
NO SIGNAL
COLOR [Blue]
SHUTDOWN [off]
Shutdown time: 5 min
Select with
↑
or
↓
then <ENTER>
<EXIT> to return.
Menu 9-16
9.6 Convergence
What can be done?
The convergence of the displayed image can be adjusted only by a qualified service technician.
How to start up?
1. Push the cursor key
↑
or
↓
to highlight Convergence . (menu 9-17)
2. Press ENTER to select.
The following message will be displayed : “Convergence is reserved to qualified service personnel.” (menu 9-18)
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
SOURCE SWITCHING
NO SIGNAL
CONVERGENCE
CONFIGURATION
LENS
QUICK ACCESS KEYS
OSD
INTERNAL PATTERNS
Select with
↑
or
↓
then <ENTER>
<EXIT> to return.
Menu 9-17
WARNING
CONVERGENCE
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return
Menu 9-18
9.7 Configuration
What can be done?
The way of physical installation of the projector can be defined to the projector.
The following installation configurations are possible:
• front/table
• front/ceiling
• rear/table
• rear/table
68 R5976445 BARCO GALAXY 15042003