Barco Galaxy NW R9040406, User Manual

Page: 31 / 209

2. Installation
C
AUTION
:
If the selected input signal is a stereo signal, a black image is displayed at the DVI output.
2.7.6 Stereo connections
What can be done ?
The stereo sources sync signals have to be connected to the 4th layer of the front panel. The stereo input layer holds 6 mini DIN
connectors and 2 BNC connectors.
The 6 mini DIN connectors are the stereo sync input connections for respectively from the left to the right, the 1 st ,2 nd and 3 rd layer.
The order is from left to right eg. for the DVI input board, the left DIN connector (L3/IN1) is for the left connector on the DVI input
board and the right DIN connector (L3/IN2) is for the right connector on the DVI input board.
DVI DVI DVI DVI 1 2
DESKTOP INPUT DESKTOP INPUT
IN1 IN1 IN2 IN2
L1 L1
STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT
L2 L2 L3 L3
IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
RS 232 C RS 232 C DVI DVI R.C. R.C.
Image 2-25
Stereo sync inputs
The BNC connectors are the stereo output sync signals. These signals will drive the emitters in case of active stereo projection
using active stereo glasses. The fact that the projector is providing two BNC is to allow the linking (stereo synchronization) of several
projectors in a multichannel projection system (see Multichannel installation).
DVI DVI DVI DVI 1 2
DESKTOP INPUT DESKTOP INPUT
IN1 IN1 IN2 IN2
L1 L1
STEREO INPUT STEREO INPUT STEREO OUTPUT STEREO OUTPUT
L2 L2 L3 L3
IN1 IN1 IN2 IN2 IN1 IN1 IN2 IN2
RS 232 C RS 232 C DVI DVI R.C. R.C.
Image 2-26
Stereo sync outputs
The 2 BNC’s are identical i.e. it does not matter to which BNC the emitter is connected.
Connecting the stereo input and output signals
1. Connect the mini-din male connector(s) to the projector’s female mini DIN connector(s)
R59770718 GALAXY NW SERIES 20/06/2013 25