Barco Galaxy NW-7, User Manual

Page: 35 / 220

4. Installation
• stereo input settings in the Image menu : to match the Image generator to the projector. "Input stereo sync", page 75
• stereo output & system settings in the Display setup menu : to match the projector to the emitters ,..."Stereo System Setup",
page 151
• stereo display settings in the Display setup menu : to decide how to display the video content. "Stereo display settings", page
130
5
'(6.723,1387 '(6.723,1387
535 535 *< *< %3% %3% +V&V +V&V 9V 9V 9,'(2 9,'(2 69,'(2
,1 ,1 ,1 ,1
/ /
67(5(2,1387 67(5(2,1387 67(5(2287387
/ / / /
,1 ,1 ,1 ,1 ,1 ,1
56& 56& '9, '9, 5& 5&
'(6.723,1387
535 *< %3% +V&V 9V 9,'(2 9,'(2 69,'(2
,1 ,1
/
67(5(2,1387 67(5(2287387
/ /
,1 ,1 ,1
56& '9, 5&
IR Emitter
Active Glasses
IR Emitter
Image Generator
Stereo output & system settings
Stereo input settings
Stereo display settings
Image 4-26
Stereo settings
See the Display setup menu (for the stereo output and system settings) and the Image menu (for the stereo
input settings)
4.5.11 Active In fi tec
TM
The Active In fi tec TM feature is optional: a software key is needed to activate it.
How to connect when using active In fi tec
TM
stereo ?
1. The input connection is done in the same way as described above but the stereo output signal is not required in this case since
In fi tec
TM
stereo glasses are required instead (these glasses are passive i.e. not switched).
4.5.12 Communication
Overview
• Network connections
• Network settings
• RS232 communication
4.5.12.1 Network connections
What can be done ?
The projector can be connected to a network allowing it to be accessed from any connected network device. The Ethernet connection
can be used to upload/download projector software and/or to set up communication (TCP-packets) with the projector. This network
can be a local area network or a small dedicated network
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013 31