Barco ELM G10, Owner'S Manual

Page: 30 / 92

4-4
Connections
5976070 BARCOELM G10 18012000
Input module insertion into the projector
To insert a module in one of the free slots, handle as follow :
1 Power down the projector and disconnect the power cord from the wall outlet.
2 Remove the dummy plate covering the chosen input slot by turning out both screws.
3 Slide the input module in the free slot. Insure the module is seated correctly in the guide grooves.
4 Press on both handles of the input module until the module plug seats in the connector of the projector.
5 Secure the input module by tightening both retaining screws.
6 Reconnect the power cord to the wall outlet and switch on the projector.
The new installed module can be selected with the digit buttons on the RCU or the local keypad.
9,'(2,1387
9,'(2 69,'(2
R G B
H / C
V
On
98
2
791
0
R G B H / C V
On
High Bandwidth RGB ANALOG INPUT
R G B H / C V
On
High Bandwidth 5 CABLE INPUT
OUT IN
On
98
40
1
1
0
6',',*,7$/,1387
OUT IN
On
98
40
1
1
0
6',',*,7$/,1387
COMM PORT TRIGGER OUT RS232/422 OUT RS232/422 IN
IR-Recei ver Diagnostic Code
Green Operation
Red Stand-by
IR Sync OK
Hardwired
remote
CTRL 1
Hardwired
remote
CTRL 2
Two way
hardwi red
remote
CTRL 3