Barco ELM G10, Owner'S Manual

Page: 23 / 92

3-9
Installation Guidelines
5976070 BARCO ELM G10 17102000
Battery installation in the RCU.
How is the battery delivered ?
A battery (not yet installed to save the battery life time) is delivered inside the plastic bag with the power cord.
How to install ?
To install the battery, remove the battery cover on the backside of the remote control by pushing the indicated handle a little towards
the bottom of the RCU. Lift up the top side of the cover at the same time (fig. 15).
Insert the new 9 V battery (type E-block or equivalent) in the lower compartment and connect the battery to the contact plate.
Insert the battery into the lower compartment and put the cover back.
Note :
Projector address has to be programmed on the RCU before using the RCU (see chapter 'Controlling').
310a.DRW
Insert here the 'Insert card
RCU' which you can cut out
on the last page of this
manual.
Contact
plate
Battery
Image 15