![background image](http://html1.mh-extra.com/html/barco/coronis/coronis_user-manual_3888049055.webp)
On-screen display (OSD)
55
ALC & DICOM Options
Continuous DICOM ALC
Introduction
When you select the DICOM DF, the display offers the possibility to take
the ambient light into account for calculating the DICOM display
function. This function is called
Continuous DICOM ALC
(ALC is short for
Ambient Light Compensation).
When Continuous DICOM ALC is switched
on
, the display will
continuously
adapt the DICOM DF based on the average measured
ambient light.
When it is switched
off
, the DICOM DF will be recalculated
only
when
another DICOM Offset is selected.
To switch continuous DICOM ALC on/off:
1.
Select the DICOM display function. See
2.
In the Display Function menu, use Up
or Down
to select
ALC &
DICOM Options
. Use Enter
to enter the submenu.
3.
In the ALC & DICOM Options menu, use Up
or Down
to select
Cont. DICOM ALC
. Use Enter
to go into edit mode.
4.
Use Up
or Down
to select On or Off.
5.
Use Enter
to save the changes.
Note:
The ambient light is measured by the ALC sensor at the
front.
DICOM offset
Introduction
When Continuous DICOM ALC is switched
off
, the DICOM DF will be
recalculated
only
when another DICOM Offset is selected. The DICOM DF
will be recalculated based on the new offset setting.
Summary of Contents for Coronis
