Barco Coronis Uniti, User Manual

Page: 12 / 70

K5902079 /11 Coronis Uniti 12
2.1 Display controller installation
About
Before you install your display and connect it with the workstation, make sure to have a suitable 1 display
controller installed in the workstation.
The Coronis Uniti display operates at its full specifications when driven by a Barco MXRT display
controller and MXRT driver (which also includes the Barco Intuitive Workflow Tools ). If you
ordered a MXRT display controller, it is included in the box of your display.
For more information and installation instructions, please check the Barco “Display Controller and
Intuitive Workflow Tools” user guide on the included documentation CD, or at
www.barco.com/
support .
2.2 Display position adjustment
About
In the factory, the tilt- and height mechanism in the display stand are locked to prevent damage during
transportation. Both mechanisms must be unlocked before you can adjust the position of the display.
To unlock the tilt mechanism
1. Position the display with its rear side facing you.
2. While pulling the bottom of the display towards the stand, pull out the red pin in the display stand.
WARNING: Before transportation of the display, insert the pin in the lock mechanism so that the
grey color of the pin isn't visible anymore.
Installation and setup
1. For a list of compatible display controllers, please refer to the compatibility matrix available at www.barco.com/mybarco/mysupport/
healthcare/compatibility-matrices