Barco Coronis Fusion 4MP, Getting Started Manual

Page: 25 / 44

Connecting the signal cables
25
Connecting the signal cables
To connect the signal cables to the display:
1.
Unpack the display and put it on a solid flat surface.
2.
Make sure the computer is turned off.
3.
To get access to the connectors, remove the connector
compartment cover (1).
To remove the cover, gently pull one side of the cover backward to
put the cover clips under stress. Then one by one, starting at the
side where you are pulling, release the 4 cover clips by pressing
with the other hand on top of the cover where the clips are
located (see drawing below).
4.
To facilitate cable routing afterwards, remove the display stand
neck cover (2). Therefore, first tilt the display panel in upright
position. Then lift and pull backward the neck cover.
5.
Also to facilitate cable routing afterwards, open both cable duct
covers (3).
Figure 5: Remove covers before connecting signal cables
1
2
3