Barco CM 100, Installation Manuallines

Page: 9 / 19

Date: 03/06/98 Page 9 Installation guidelines
R9827341
R9827342
CM 100
5. Projector-position correction
a. Projector water-level adjustment
Unscrew the nuts 1on each rod and turn the screws 5cm above the lower support.
WARNING: BE AWARE THAT FOR THE WATER-LEVEL ADJUSTMENT THE USED
NUTS REMAIN SCREWED ON THE ROD FULLY.
Put the water-level on a side of the projector, loosen nut 3 slightly and turn the nut 2 on this side until the
projector is level. Further, put the water-level on the adjacent side and adjusts the opposite nut2 for water-
level. Do the same adjustment for the following adjacent side.
Secure the water-level postion of the projector by fastening the nuts 2 (the lower support is clamped between
nut 1 and 2). Secure nut 2 by tightening the locking-nut 3 against nut 2
IMPORTANT : On each corner of the lower support, an ajustable screw (D) allows a small correction for the
projector water-level. Turning clockwise lifts up the projector on the respective side, while turning anti-
clockwise, lowers the projector. To make this ajustment possible, loosen the safety-nuts (G) slightly until a
vertical movement of the projector is possible.
After adjusting make sure that the safety-nut is tightened again.
'
187
187
6$)(7<3,1)
6$)(7<187*
187